Napoleon Attitude AX42NTE Installation Manual

Also see for Altitude AX36NTE: Owner's manual Installation manual Installation manual

Contents

Napoleon Attitude AX42NTE Installation Manual Manual pdf 38 page image

W415-1935 / A / 05.07.19EN38finishing9.6 clearances around appliance6” min.ATop of finishing flange(fireplace opening)2.5” min.2” min. (3” max. recommended)6” min.A or B2.5” min.6” min.2.5” min.ASee “minimum clearance tomantle” section (installationmanual).EnclosureEnclosureEnclosureTV bracketTV bracketTV bracketFlush installation with mantelPartially recessed installation with mantelRecessed installation with protrusionTop of finishing flange(fireplace opening)Top of finishing flange(fireplace opening)2” min. (3” max. recommended)2” min. (7” min. recommended)Top offinishingflange(fireplaceopening)EnclosureTV bracketFlush installation without mantelAppliance ApplianceApplianceApplianceThe volume of air must be added to the enclosureto accomodate the recessed area.BMantle clearances reducedto 4” from opening withthe use of the heat managementsystem.• These are recommended minimum clearances only and are in supplied in good faith and not a guaranteeof compliance with TV manufacturers’ maximum allowable operating temperatures. Always comply to TVmanufacturers’ requirements.• TV temperatures must be validated at the time of installation as air flow characteristics within theroom can vary and maximum acceptable operating temperatures can vary from appliance to appliance.TVs cannot be used where the TV temperature exceeds the manufacturer’s maximum allowable operatingtemperatures (see TV manufacturer’s specifications).• Mantel height and depth must conform to mantel clearance requirements specified in this manual, see“minimum clearance to combustible mantel” section in installation manual.• Dimension “A” the gap between the top of the finishing fl ange and the bottom of the TV are taken from thetop of the appliance opening.• TV temperatures may be further reduced by increasing the horizontal distance between the front of the TVand the front edge of the mantel or by increasing dimension “A”. However, increasing the gap between thetop of the mantel and the bottom of the TV beyond the maximum recommended figure, typically results inhigher temperatures. Minimum clearance between the mantel and bottom of the TV should be maintained toallow air circulation below and behind the TV.note: