Napoleon Attitude AX42NTE Installation Manual

Also see for Altitude AX36NTE: Owner's manual Installation manual Installation manual

Contents

Napoleon Attitude AX42NTE Installation Manual Manual pdf 44 page image

W415-1935 / A / 05.07.19EN44maintenance10.4 night light replacementSCREWSFIREBOX TOPLENS ASSEMBLYGASKETLENSFRAMEAMBERSIDE UPYour appliance comes equipped with our Night Light ™. The light hasbeen pre-wired and can be controlled from the switch on the controlpanel.It is recommended that the Night Light ™ be in the “OFF” position whenthe appliance is on.In the event the lamp or lens needs to be replaced:• Unplug the light from inside the appliance.• Remove the 4 screws that secure the lens frame. This frame retainsthe glass lens.• The lamp can now be accessed. It will pull straight out of the socket.note:Do not handle the lamp (bulb) with bare fingers as it may behot. Use a clean, dry cloth for protection.note:Do not over-tighten the screws, as this could break the lens.• Replace the lamp with Wolf Steel parts only, as lamp and lens arespecial “high temperature” products.• When re-installing, ensure integrity of gasket seal.THE FIREBOX MUST BE SEALED.! WARNING• Risk of fire and electrical shock!• Turn off the gas and electrical power before servicing this appliance.• Use only Wolf Steel approved optional accessories and replacement parts with this appliance. Usingnon-listed accessories (blowers, doors, louvres, trims, gas components, venting components, etc.) couldresult in a safety hazard and will void the warranty and certification.• Ensure that the fan’s power cord is not in contact with any surface of the appliance to prevent electricalshock or fire damage. Do not run the power cord beneath the appliance.• The wire harness provided in the blower kit is a universal harness. When installed, ensure that any excesswire is contained, prevent it from making contact with moving or hot objects.A. Turn off the power to the appliance.B. Remove the safety barrier.C. Remove the control panel (2 screws).D. Unplug the blower from the control board.E. Undo the fastener at the left side of the blower mounting plate. The assembly should now slide to the left,away from the mounting tab.F. Disconnect the slip-on connectors at the motor of the blower.G. Replace the blower in assembly and reverse previoussteps.Drywall dust will penetrate into the blower bearings, causingirreparable damage. Care must be taken to prevent drywalldust from coming into contact with the blower or its compart-ment. Any damage resulting from this condition is not coveredby the warranty policy.10.5 blower replacement“Light leakage” from the upper area may be noticed. The holes in the lamp housing are necessary for ventilationand must not be covered.