Napoleon Attitude AX42NTE Installation Manual

Also see for Altitude AX36NTE: Owner's manual Installation manual Installation manual

Contents

Napoleon Attitude AX42NTE Installation Manual Manual pdf 36 page image

W415-1935 / A / 05.07.19EN36finishing11”(28cm)9.4 installing non-combustible boardNon-combustible facing material must not project more than 4” (101.6mm) from the face of the door (all foursides). If greater projections are desired, increase the clearance to the sides, bottom and top by 2” (50.8mm) forevery additional 1” (25.4mm) of projection. If using an optional surround, the same rule applies, starting from thetop of the surround. Ensure clearances are maintained for surround removal, as it must lift off the appliance formaintenance.! WARNING1. Align the non-combustible panel against the appliance.2. Mark the non-combustible panel to pre-drill holes.3. Secure the non-combustible panel to the appliance.Non-combustible panel shipped loose in carton.note:Joint Compound where requiredJoint compounds such as Durabond 90 and tapes that are resilient to heat and cracking should be used whentaping and mudding seams.Setting tiles and groutingWe recommend you use tiles with a dry butt joint to be installed using a two-part mortar with an acrylic latexadditive, such as Mapei Kerabond/Kerlastic, to allow for slight movement in the normal operation of the appliance.If grout is used between the tiles, a polymer-based grout, such as Mapei Ultracolour plus, is recommended.Primer/PaintFor a painted surface, use a 100% acrylic latex primer and finish coat. Light coloured paints may discolour.AX36 AX42WIDTH 35 1/4” (89.5cm) 42 1/4” (107.3cm)Do not notch the framing around the appliancestandoffs. Failure to maintain air clearance spacecould cause overheating and/or fire.note: