Remote Annex Administrator’s Guide for UNIXChapter 3 Using the CLI CommandsBook C-184Book CIf you issue the slip command, and the port is not configured properlyfor SLIP, the terminal displays This port cannot be used for SLIP (formore details on using a SLIP link, see Serial Line Internet Protocol (SLIP)on page A-137).The remote host must be configured to use these addresses.Resetting the port returns it to CLI mode.You cannot use the minimum uniqueness feature with theslip command.statsThe stats command displays Remote Annex statistics. Table C-62describes the arguments for stats. The syntax is:stats [–sm [ports][time] |[–op]Table C-62. Arguments for the stats Command(continued on next page)Argument Description–s Displays statistics for all serial ports. You can enter a single port(–s5) or a range of ports (–s5–10 or –s5,7,9–12). This argumentalso displays control line status in which an asserted signalappears in upper case letters and a de-asserted signal appears inlower case letters.–s time Displays serial line statistics, pausing between each display thenumber of seconds specified by time. Entering the attentioncharacter, attention string, or the Break key aborts the display.–m Displays statistics for active control lines much the same as –s,but displays the modem controls for inactive control lines (i.e.,unattached slave lines) rather than displaying idle.
