Book C-35Chapter 2 Configuration ParametersRemote Annex Administrator’s Guide for UNIXBook CSetting Parameters to Supplied DefaultsEach configuration parameter, except the Annex’s IP address, has adefault value. Using the na command set, you can return any parameterto its default setting (for more details, see set on page Book C-24).Depending on the parameter type, the syntax options are:Setting AnnexParameters1. set annexannex_parameter 0The set annexannex_parameter 0 command sets parameters thatrequire a numeric value. For example, to set pref_dump_addr to itsdefault, 0.0.0.0, enter:command: set annex pref_dump_addr 02. set annexannex_parameter ""The set annexannex_parameter "" command sets all parametersthat require a string value; these parameters default to either a nullstring ("") or “”. For example, to set image_name to itsdefault, a null string (""), enter:command: set annex image_name ""3. set annexannex_parameter defaultThe set annexannex_parameter default command sets all otherparameters. These parameters are set by choosing either an optionfrom a known list or a yes/no response. For example, to setenable_security to its default, N, enter:command: set annex enable_security defaultSetting InterfaceParametersTo set an interface parameter to its default value, use the set interfacecommand:1. set interface [=interface_set]interface_parameter ^@2. set interface [=interface_set]interface_parameter " "3. set interface [=interface_set]interface_parameter defaultSetting T1Parameters1. set t1t1_parameters
