Book C-81Chapter 2 Configuration ParametersRemote Annex Administrator’s Guide for UNIXBook CTo set an inactivity timer of two minutes, set:net_inactivity_units=minutesnet_inactivity=2To set an inactivity timer of 30 seconds, set:net_inactivity_units=secondsnet_inactivity=30An inactivity timer can be set to the following combinations:0 to 4 minutes 15 seconds (= 255 seconds) in 1 second intervals0 to 4 hours 15 minutes (= 255 minutes) in 1 minute intervalsnetwork_turnaroundThis Annex parameter defines the approximate number of seconds thatan Annex waits for a response from a security server (an algorithm definesthe actual time which typically is longer than the defined value). Thisparameter works only when the enable_security parameter is set to Y.Allowable values range from 1 to 255. The default is 2.Setting this parameter to a high number is not recommended unless alarge timeout value is required for contacting (for security) slow hosts orwaiting for a slow host’s response to a security request.newline_terminalThis asynchronous port parameter interprets carriage returns and linefeeds at the CLI level. When enabled, a line feed terminates both the inputand the output lines. When disabled, a carriage return or a line feedterminates the input line and a carriage return followed by a line feedterminates output lines. A Y enables this parameter, an N disables it. Thedefault is N.
