Remote Annex Administrator’s Guide for UNIXChapter 2 Configuration ParametersBook C-54Book Cconfig_fileThis Annex parameter defines the file name for the configuration filemaintained on the load host. This file contains information aboutgateways, rotaries, macros, and services; it must reside in the directory /usr/spool/erpcd/bfs. The default file name is config.annex.connect_securityThis asynchronous port parameter enables the host-based security policyfor access from the CLI to the network (using telnet and rlogin only). Ifconnect_security is enabled, the user must receive authorization toconnect to a host on the network. The supplied security policy scans thefile /install-directory/acp_restrict to authorize a connection to a hostfrom the Annex. If authorization is not granted, the connection is notmade. A Y enables this parameter, an N disables it. The default is N.control_linesThis asynchronous port parameter defines the type of hardware controllines used on this port. Table C-22 describes the valid options; the defaultis none.Table C-22. Valid Options for the control_lines ParameterOption Descriptionboth Allows both flow control and modem control.flow_control Configures the control lines for flow control (RTS/CTS), but does not activate hardware flow control.modem_control Configures the control line for modem control usingDTR/DCD/DSR hand-shaking.none Does not implement hardware control lines.
