222 Chapter 13 VPNNN47922-500The two Business Secure Routers shown in Table 55 cannot complete theirnegotiation because Business Secure Router B’s Local ID type is IP, but BusinessSecure Router A’s Peer ID type is set to E-mail. An “ID mismatched” messagedisplays in the IPSEC LOG.My IP AddressMy IP Address is the WAN IP address of the Business Secure Router. TheBusiness Secure Router has to rebuild the VPN tunnel if the My IP Addresschanges after setup.The following applies if this field is configured as 0.0.0.0:• The Business Secure Router uses the current Business Secure Router WAN IPaddress (static or dynamic) to set up the VPN tunnel.• If the WAN connection goes down, the Business Secure Router uses the dialbackup IP address for the VPN tunnel when using dial backup or the LAN IPaddress when using traffic redirect. See Chapter 7, “WAN screens,” on page105 for details about dial backup and traffic redirect.Configuring Branch Office VPN Rule SetupSelect one of the VPN rules in the VPN Summary screen and click Edit toconfigure the rule’s settings. The VPN Branch Office Rule Setup screen isshown in Figure 72.Table 55 Mismatching ID Type and Content Configuration ExampleBusiness Secure Router A Business Secure Router BLocal ID type: IP Local ID type: IPLocal ID content: 1.1.1.10 Local ID content: 1.1.1.10Peer ID type: E-mail Peer ID type: IPPeer ID content: aa@yahoo.com Peer ID content: N/A
