32 CS 1000 configurationPrompt Response DescriptionsPNI (0)-16283 Private Network IdentifierWithin one network, use the same PNIvalue in LDs 15 and 16. When youinterwork with different networks, enterthe PNI of this CS 1000 system in LD15, and the PNI of the target or remoteCS 1000 system in LD 16.The default PNI = 0 prevents theoperations of features such as NRAG,NACD and NMS.HLOC xxx Home Location Code, where xxx =HLOC value defined in LD 90.Prompted when ISDN = YES or withDigital Private Network SignalingSystem (DPNSS) package 123.LSC yyy Local Steering Code (LSC), where yyy= LSC defined in LD 15.LSC is required if the coordinatedDialing Plan (CDP) DNs are longerthan the local PDNs. The LSC promptappears only if a 5 or 6 dialing plan isconfigured or if DPNSS is equipped.Configuring the route data blockIf you have purchased Network Message Service (NMS) to allow a numberof switches to share CallPilot (installed on only one switch), then configurethe route data block.For details on additional switch configuration for NMS, refer to CallPilotNetwork Planning Guide (555-7101-102).Ensure that Digit Manipulation (DMI in LD 86) is not used to insert ESNaccess codes at the sending switch. ESN access code insertion must bedone at the receiving switch (INAC in LD 16).Configuring the route data blockStep Action1 Connect to the Call Server.2 Enter LD 16.3 Enter the appropriate values as described in the following table.For prompts not listed in the following table, press Enter to acceptthe default.Enterprise: CommonSolution Integration Guide for Communication Server 1000/CallPilot/Contact Center/Telephony ManagerNN49000-300 01.01 StandardCS 1000 Release 4.5 20 December 2006Copyright © 2006, Nortel Networks Nortel Networks Confidential.
