63CallPilot configurationThis chapter describes the configuration of the switch information forCallPilot. It is assumed that CallPilot is installed and configured and that theswitch information was not configured during initial the initial configuration.The procedures in this chapter are sequential. You must complete theseprocedures in order, uninterrupted, to avoid losing all changes.CallPilot configuration proceduresThe sequence of CallPilot configuration procedures is as follows:• "Logging on to CallPilot Manager" (page 63)• "Configuring the keycode and serial numbers" (page 66)• "Configuring CallPilot server information" (page 68)• "Configuring password information" (page 69)• "Configuring multimedia allocations" (page 70)• "Configuring the CS 1000 switch information" (page 71)• "Configuring the links on the MGate card" (page 72)• "Configuring CDN information" (page 74)• "Configuring the Contact Center Language Source" (page 75)• "Configuring the CallPilot LAN interface" (page 76)Logging on to CallPilot ManagerPerform the following procedure to log on to CallPilot Manager.Your computer must be connected to the same network to access CallPilotManager through the web browser.Enterprise: CommonSolution Integration Guide for Communication Server 1000/CallPilot/Contact Center/Telephony ManagerNN49000-300 01.01 StandardCS 1000 Release 4.5 20 December 2006Copyright © 2006, Nortel Networks Nortel Networks Confidential.
