Front panel connector pin assignments 165MemoryCP PIV memory uses DDR SDRAM technology. The CP PIV providesa maximum of two GBytes using two verticall DIMM sockets to installoff-the-shelf DIMM modules. CP PIV only supports DDR SDRAM DIMMmemory with a supply voltage of +2.5V.are supportedThe memory data path is 72-bit wide. The Intel 855GME HostBridge supports 64 Mbit, 128 MByte, 256 MByte and 512 Mbyte SDRAMtechnologies with a maximum ROW page size of 16 Kbytes and CASlatency of 2 or 2.5. The maximum height of the DIMM modules possibleon CP PIV is one inch or 25.4 mm.The DDR interface runs at 100 MHz synchronously to the front side busfrequency. The SPD (Serial Presents Detect) -SROM available on DIMMmodules provide all necessary information (speed, size, and type) to theboot-up software. The SPD-SROM can be read via SMBUS connected tothe Intel Hance Rapids South Bridge.Front panel connector pin assignmentsCOM1 and COM2 portsThe physical interface for the COM1 and COM2 ports to the front panel isthrough a stacked dual Male DB9 Connector. The corresponding pin detailsare shown in Table 72 "COM1 and COM2 pin assignments" (page 165).Table 72COM1 and COM2 pin assignmentsPin number Pin name1 DCD2 RXD3 TXD4 DTR5 GND6 DSR7 RTS8 CTS9 RIUSB portThe physical interface for thetwo USB ports to the front panel is through astandard USB connector. The corresponding Pin details are shown in Table73 "USB connector pin outs" (page 166).Table 27. USB Connector Pin OutsNortel Communication Server 1000Circuit Card ReferenceNN43001-311 01.04 StandardRelease 5.0 23 May 2008Copyright © 2003-2008, Nortel Networks.