Planning GroupWise in a Heartbeat Cluster 293novdocx (en) 11 July 200830.6.3 Planning the Linux Agent InstallationAside from the cluster-specific issues discussed in the preceding sections, the considerationsinvolved in planning to install the GroupWise Linux agents are the same in a clustering environmentas for any other environment. Review “Planning the GroupWise Agents”, then print and fill out the“GroupWise Agent Installation Worksheet” in “Installing GroupWise Agents” in the GroupWise 7Installation Guide for each domain and post office for which you will install the Linux MTA orPOA.IMPORTANT: Do not install the Linux agent software until you are instructed to do so inChapter 32, “Setting Up a Domain and a Post Office in a Heartbeat Cluster,” on page 307.Skip to Chapter 32, “Setting Up a Domain and a Post Office in a Heartbeat Cluster,” on page 307.30.7 GroupWise Clustering Worksheets Section 30.7.1, “Heartbeat Clustering Worksheet,” on page 293 Section 30.7.2, “GroupWise Clustering Worksheet,” on page 29430.7.1 Heartbeat Clustering WorksheetItem Explanation1) HA Management Client Password: Specify the password you use to access the GUI HAManagement Client.For more information, see Section 30.1.1, “RecordingHeartbeat Cluster Information,” on page 286.2) Nodes in Cluster: List the nodes in your Heartbeat cluster that you will use inyour GroupWise system. Identify each node by its hostnameand its physical IP address on your network.For more information, see Section 30.1.1, “RecordingHeartbeat Cluster Information,” on page 286.3) EVMS Container Resources: Specify the names of the EVMS failover container resourcesthat you want to represent partitions of shared storageprovided by the SAN in your cluster.For more information, see Section 30.1.1, “RecordingHeartbeat Cluster Information,” on page 286.4) File System Resources: Device Directory File system typeList the EVMS device name (for example, /dev/evms/gwsystem/gwvol1), the mount point directory (/mnt, /gwsystem, etc.), and file system type (reiserfs, ext3, etc.),for each file system.For more information, see Section 30.1.1, “RecordingHeartbeat Cluster Information,” on page 286.
