Setting Up a Domain and Post Office in a NetWare Cluster 65novdocx (en) 11 July 2008 Providing access to users’ GroupWise mailboxes from their Web browsers. See Chapter 5,“Implementing WebAccess in a NetWare Cluster,” on page 89. Connecting your clustered GroupWise system to other e-mail systems through GroupWisegateways. See Chapter 6, “Implementing GroupWise Gateways in a Novell Cluster,” onpage 107. Monitoring the status of your clustered GroupWise system from your Web browser. SeeChapter 7, “Monitoring a GroupWise System in a NetWare Cluster,” on page 109. Backing up your clustered GroupWise system. See Chapter 8, “Backing Up a GroupWiseSystem in a NetWare Cluster,” on page 111.3.9 Clustering Quick Checklists Section 3.9.1, “GroupWise System Quick Checklist,” on page 65 Section 3.9.2, “Domain Quick Checklist,” on page 66 Section 3.9.3, “Post Office Quick Checklist,” on page 673.9.1 GroupWise System Quick Checklist Plan your new clustered GroupWise system.See Chapter 2, “Planning GroupWise in a NetWare Cluster,” on page 23. Cluster-enable the volumes where GroupWise domains and post offices will reside.See Section 3.1.2, “Cluster-Enabling Shared Volumes for Use with GroupWise,” on page 43. Make sure that short name resolution works throughout your network.See Section 3.1.3, “Configuring Short Name Resolution,” on page 44. Create the primary domain and initial post office in your new clustered GroupWise system.See Section 3.2, “Setting Up a New GroupWise System in a Cluster,” on page 46. Set up the agents for the primary domain and the initial post office.See Section 3.5, “Installing and Configuring the MTA and the POA in a Cluster,” on page 50. Modify the volume resource load script(s): Remove the trustmig command Add the cvsbind add command (NetWare 5.1 only; optional) Add the search add command (optional) If you will not run the agents in protected memory, add the set auto restartcommands and the set developer option = off command Add the agent load command(s) If you will run the agents in protected memory, add the address space parameter tothe load command(s) and add a corresponding protection restart command foreach address spaceSee “Modifying the Volume Resource Load Script for the Agents” on page 53. Modify the volume resource unload script(s): Add the agent or address space unload command(s)
