416 GroupWise 7 Interoperability Guidenovdocx (en) 11 July 2008“Deciding Where to Install the Agent Software” on page 393, which describes the issues in thecontext of planning MTA and POA installations. As with the MTA and POA, the Internet Agent andits MTA must be installed as Windows services.43.1.6 Planning the MTA InstallationFollow the instructions in “Planning the Windows Agent Installation” on page 395 to plan the MTAinstallation for the Internet Agent domain, then return to this point. After you follow theinstructions, you will have a filled-out Windows Agent Worksheet to use when you install the MTA.IMPORTANT: Do not install the Windows MTA until you are instructed to do so in Section 43.2,“Setting Up the Internet Agent in a Cluster,” on page 416.43.1.7 Planning the Internet Agent InstallationAside from the cluster-specific issues discussed in the preceding sections, the considerationsinvolved in planning to install the Internet Agent are the same in a Microsoft cluster as for any otherenvironment. Review “NetWare and Windows: Installing the Internet Agent Software”, then printand fill out the “GroupWise Internet Agent Installation Worksheet” in “Installing the GroupWiseInternet Agent” in the GroupWise 7 Installation Guide. You need this information as you install theInternet Agent in your cluster.IMPORTANT: Do not install the Internet Agent software until you are instructed to do so inSection 43.2, “Setting Up the Internet Agent in a Cluster,” on page 416.43.2 Setting Up the Internet Agent in a ClusterYou should already have reviewed Section 43.1, “Planning the Internet Agent in a Cluster,” onpage 413 and filled out Section 43.4, “Internet Agent Clustering Worksheet,” on page 422. You arenow ready to complete the following tasks to set up the Internet Agent in a Microsoft cluster: Section 43.2.1, “Setting Up the Internet Agent Resource Group,” on page 417 Section 43.2.2, “Creating a Domain for the Internet Agent,” on page 417 Section 43.2.3, “Installing the MTA for the Internet Agent Domain,” on page 417 Section 43.2.4, “Installing and Configuring the Internet Agent in a Cluster,” on page 417 Section 43.2.5, “Testing the Clustered Internet Agent,” on page 420INTERNET AGENT CLUSTERING WORKSHEETUnder Item 4: MTA Installation Location and Item 6: Internet Agent Installation Location, mark whetheryou will install the Internet Agent and its MTA to the shared disk of the Internet Agent resource groupor to each node in the cluster. If necessary, specify where the MTA startup file and the Internet Agentconfiguration file (gwia.cfg) will be stored.
