Implementing the Internet Agent in a NetWare Cluster 73novdocx (en) 11 July 20084.1.8 Planning the MTA InstallationFollow the instructions in “Planning the NetWare Agent Installation” on page 37, then return to thispoint. After you follow the instructions, you have a filled-out NetWare Agent Worksheet to usewhen you install the MTA.IMPORTANT: Do not install the NetWare MTA until you are instructed to do so in Section 4.2,“Setting Up the Internet Agent in a Cluster,” on page 73.4.1.9 Planning the Internet Agent InstallationAside from the cluster-specific issues discussed in the preceding sections, the considerationsinvolved in planning to install the Internet Agent are the same in a clustering environment as for anyother environment. Review the installation instructions in “NetWare and Windows: Installing theInternet Agent Software” in “Installing the GroupWise Internet Agent” in the GroupWise 7Installation Guide. You might want to print this section and write down the types of planninginformation you have provided on worksheets in other sections. You will need this information asyou install the Internet Agent in your cluster.IMPORTANT: Do not install the Internet Agent software until you are instructed to do so inSection 4.2, “Setting Up the Internet Agent in a Cluster,” on page 73.4.2 Setting Up the Internet Agent in a ClusterYou should already have reviewed Section 4.1, “Planning the Internet Agent in a Cluster,” onpage 69 and filled out the Section 4.4, “Internet Agent Clustering Worksheet,” on page 84. You arenow ready to complete the following tasks to set up the Internet Agent in a clustering environment: Section 4.2.1, “Cluster-Enabling a Shared Volume for Use with the Internet Agent,” on page 73 Section 4.2.2, “Creating a Domain for the Internet Agent,” on page 74 Section 4.2.3, “Installing the MTA for the Internet Agent Domain,” on page 74 Section 4.2.4, “Installing and Configuring the Internet Agent in a Cluster,” on page 74 Section 4.2.5, “Testing the Clustered Internet Agent,” on page 824.2.1 Cluster-Enabling a Shared Volume for Use with theInternet AgentTo cluster-enable the Internet Agent shared volume:1 Complete the cluster-enabling steps in the applicable section of the cluster documentation foryour version of NetWare, as listed in Chapter 1, “Introduction to GroupWise 7 and NovellCluster Services on NetWare,” on page 21.The Internet Agent Clustering Worksheet provides the volume to cluster-enable, the cluster-enabled volume IP address, and the failover path for the Internet Agent volume.For a review of the new Novell ® eDirectoryTM objects that are created when you cluster-enablea shared volume, see Section 2.6, “Deciding Whether to Cluster-Enable the Shared VolumesUsed by GroupWise,” on page 27.
