OHAUS Explorer Pro Instruction Manual

Also see for EXPLORER PRO: Service manual Instruction manual Instruction manual

ExplorerPro EN-13ADJUSTMENTSThree soft-keys at the top of the display screen labeled UNITS,2nd UNITS and CALIBRATE are accessed by using the arrowbuttons and selected by pressing the Enter button.CALIBRATEWhen the CALIBRATE soft key is highlighted, and the Enter buttonis pressed, calibration can be performed.2ND UNITSWhen 2nd UNITS is highlighted, each press of the Enter buttoncycles through the measuring units that are turned On in theUnits menu. The last option when cycling through the units isOff.UNITSWhen UNITS is selected and highlighted, each press of the Enterbutton cycles through the measuring units that are On and willappear adjacent to the large numerals.3.4.2 Parts CountingThe three different Parts Counting modes can be selected, Count,Check or Fill in the Parts Counting Setup. Each mode is describedseparately.USEPARTS COUNTINGIn the Parts Counting mode, the balance displays the quantity ofparts you place on the pan. Since the balance determines thequantity based on the average weight of a single part, all partsmust be reasonably uniform in weight.The balance has a default setting of 10 pieces. This permitsstarting parts counting immediately without setting up the balance.The following display indicates the first time operation of partscounting.PA R T S CO U NTING 01/01/03 03:05:45 PMS AMPLE S I Z E S ET U P NEW CO UNTAdd 10 Pieces, Press Enter0.00 g0g 6100gAPW: 0.00gS ample S ize: 10Tare: 0.00gTare the balance if required. With the NEW COUNT soft keyhighlighted, press the Enter button. Place 10 pieces on the panas instructed by the blinking text on the display. Press the Enterbutton.The display now indicates the Average Piece Weight (APW) andthe sample size.PA R T S CO U NTING 01/01/03 03:05:45 PMS AMP LE S I ZE S ET U P NEW COU NT20.00 g0g 6100gAPW: 2.00gS ample S ize: 10Tare: 0.00g10 Pcs*ADJUSTMENTSThe Parts Counting display contains three soft keys at the top ofthe screen SAMPLE SIZE, SETUP and NEW COUNT.NEW COUNTWhen NEW COUNT soft key is selected, follow the screeninstructions “Add 10 Pieces, Press Enter “. After pressing theEnter button, the balance calculates the APW and the displayindicates the number of pieces.SETUPSelect the SETUP soft key and press the Enter button. The PARTSCOUNTING SETUP is shown.Place parts to be counted on the pan. Balance displays numberof pieces.