changing the value of the [Paper quality] setting to [Low] or even [Lower]. However, this affectsthe productivity by almost 5 and 10% respectively.Please refer to the Troubleshooting chapter for more information (seeTroubleshooting onpage 278).[Paper quality test]This test helps you to check if the correct [Paper quality] setting is set. In the Settings Editor, youcan select the media for this test. It is advised to choose the same media as used for the job. Or,in other cases, choose media which covers the width of the media used as a minimum. When youstart the [Paper quality test], the printer sends 5 empty sheets of the selected media to the systemoutput. This is done after each of the next 5 black image cleaning procedures. Keep in mind thatthis can last 2500, 1250 and 1000 sheets when the [Paper quality] setting is set to [Normal], [Low]and [Lower] respectively. Then the test stops and the print job continues without interruption.Check the last set (fifth) of the empty sheets to see if the [Paper quality] setting is cleaning theprint process properly. The sheets should show no pollution.NOTEWhen the system goes into standby mode before the [Paper quality test] has finished, the [Paperquality test] starts again.Before you begin1. On the control panel, touch the [System] button.2. Touch [Setup].3. Touch the [Advanced media settings] button in the [Advanced] section.4. Enter the maintenance PIN when you change a setting.NOTEThe control panel will only ask you to enter the maintenance PIN when amaintenance PIN is defined in the Settings Editor.Change the advanced media settings - Enable the [Low temperature mode]Procedure1. Touch the [Low temperature mode] button.The text on the button changes from [Off] to [On].NOTEEach time you touch the button, the setting changes from [On] to [Off] and the otherway round.2. Press [OK].When the [Low temperature mode] is [On], this is visible on the dashboard.Change the advanced media settings - Enable the [Low temperature mode]Chapter 11 - Media handling 217Océ VarioPrint 6000 line
