Perform a media registration for standard-size media - Adjust theX-position of side 2Procedure1. Take the first test sheet.2. Align the start of the ruler with point 'N' of the test sheet.Test bitmap: REGISTRATIONSize: 210 x 297 mm2006-10-09 / 14:08:36Page 22Secondary image 05-005+2epahSdnomaiDyradnoceS205-005+1epahSdnomaiDyradnoceS1 05-005+noitisopegamiXyradnoceS5-500+50SecondaryZimageposition4-500+50PrimaryXimagepositionPrimaryZimageposition1000105011001150120012501300135014001450150015501600165017001750180018501900195020002050210021502200225023002350240024502500255026002650270027502800PrimarydiamondshapeXlengthKNLP-500+50PrimaryXimagepositionPrimaryZimageposition05-005+tisopegamiXyradnoceS5N-500+50[57] Align the ruler with 'N'3. Read the value at the edge of the test sheet.4. Enter the value.5. Take the second test sheet.6. Repeat the steps 2 - 4.7. Take the third test sheet.8. Repeat the steps 2 - 4.ResultA pop-up message appears. The message asks you whether you want to print an extra test sheetto verify the result of the registration. You can do one of the following.• Press [Yes] if you want to print an extra test sheet to verify the result.Wait for the sheet and check the result. Another pop-up message appears. Press [Yes] if theregistration is correct. Press [No] if the registration is not correct. Then the registrationprocedure will start again.• Press [No] if you do not want to print an extra test sheet. The registration procedure will befinished.Perform a media registration for standard-size media - Adjust the X-position of side 2228 Chapter 11 - Media handling Océ VarioPrint 6000 line
