271Clean soft fuser roller[360]CautionThe components in the fuser station reach a surface temperature of approx-imately 230 o C. Touching the components can cause burns.Do not touch any parts behind the safety covers identified with this icon:[361]3. [362]Turn the knob on the cleaningstation to the left.4. Swivel on cleaning station.[363]CautionThe components in the fuser station reach a surface temperature of approx-imately 230 o C. Touching the components can cause burns.Allow the printing system to cool down for at least 30 minutes, with the fus-er station open.Put on the heat protection gloves.5. Allow the printing system to cool down for approximately 30 minutes.6. Put on heat protection gloves.7. [364]Press against the pressure pinand swivel out the waste collec-tor.8. Soak a fluff-free towel (e.g. paper towel) with cleaning agent 6-1508/W1/H.Proceed as follows:
