413Replacing the cleaning belt - overviewReplacing the cleaning beltReplacing the cleaning belt - overviewIntroductionThe printing system detects the end of the cleaning belt's service life automaticallyand displays a timely warning on the operator panel.Caution:During operation, the components in the fuser station reach a surfacetemperature of approximately 230o C. Touching the components can causeburns. Do not touch any hot parts behind the safety covers (see Warning andinformation signs on page 33).Wear heat protection gloves when working with fuser station components.OverviewThe following procedure is for replacing the cleaning belt:■ Remove cleaning belt on page 414■ Install cleaning belt on page 416
