Oce WP20 Operation Manual

Contents

Chapter 1 Using the Operator Panel1-11• Items and values on the status page may vary depending onthe printer’s firmware version.• The network status page will also be printed after the statuspage if the option network interface card is installed. For de-tails, seePrinting Option Network Status Page on page 1-12.1 Software VersionThis information shows the firmware version and date ofissue of the printer.2 Hardware InformationThis information shows various printer settings, such asthe size and type of the paper in the paper cassettes.3 MemoryThis shows the amount of total memory installed in theprinter, the amount of currently available memory, andthe current status of the RAM disk. SeeOperating RAMDisk on page 1-50.4 Page InformationThis shows the print resolution, number of copies, andthe total page count.5 Installed OptionsThis shows the option(s) installed in the printer.6 Network StatusThis shows the IP address, Subnet Mask address, andDefault Gateway address for the network interface.7 EmulationThis shows all available emulations of the printer. Theprinter is shipped from the factory with PCL 6 emulationselected as the default.8 Error LogThis shows the last three instances of the following typesof errors, listing them in the order of their occurrence:KPDL error; memory related error; or memory card re-lated error. The most recent error is displayed on thetop line of the Error Log. For error remedies, seeMaintenance Messages on page 4-4. Error information iscleared when the printer’s power is turned off.9 Toner GaugeThis shows the approximate level of remaining toner.When the value is 100, the toner container is full.10 Interface InformationThis information shows the default font and the defaultemulation for all interfaces installed in the printer.11 KIR Test PatternKIR is the Kyocera’s original smoothing function. Thistest pattern shows the effect of the KIR (Kyocera ImageRefinement) system.The service status page contains printer settings informationthat is more detailed than the standard status page and istherefore for mostly service purposes. To print a service sta-tus page, proceed as follows;Press the MENU key.Press the or key repeatedly until Others > ap-pears.Press the key.Press the or key repeatedly until >Service >appears.Press the key.Press the or key repeatedly until >>PrintStatus Page appears.Press the ENTER key. A question mark (?) appears.Press the ENTER key. The message display indicatesProcessing and printing starts. When printing iscompleted, the message display returns to Ready.NOTE Printing Service Status PageOthers >>Service >>>PrintStatus Page>>PrintStatus Page ?12345678