Chapter 1 Using the Operator Panel1-36This mode enables you to print the requested number of cop-ies of a job, simultaneously storing the job on the hard disk.When additional copies are required, you can reprint the re-quired number of copies from the printer operator panel. Toprint a job as a quick copy job, seePrinter Driver Guide.The default number of print jobs that can be stored on thehard disk is 32. This value can be increased to up to 50 fromthe e-MPS Configuration menu. For details, seeChanging theMaximum Number of Quick Copy/Proof-and-Hold Jobs onpage 1-40. When the number of jobs reaches the limit, the old-est job will be overwritten by the new one.When the printer is turned off, all stored jobs will be deleted.Printing Additional Copies Using Quick CopyTo print additional copies of a job stored in the printer:Press the MENU key.Press the or key repeatedly until e-MPS > ap-pears.Press the key.Press the or key repeatedly until >QuickCopy appears followed by the user name (Harold, inthis example). The user name is assigned at printingusing the printer driver.Press the ENTER key. A blinking question mark (?)appears before the user name.Press the or key to display the desired username, Arlen, in this example.Press the ENTER key. The job name entered in theprinter driver (Report, in this example) appear witha blinking question mark (?) before the letters.Press the or key to scroll to the desired job ti-tle.Press the ENTER key. The number of copies to beprinted can be set. To increase the copy count, pressthe key; to decrease the copy count, press thekey.Press the ENTER key to finalize the copy count. Theprinter prints the specified number of copies for thejob.Deleting a Quick Copy JobAll quick copy jobs are automatically deleted when the print-er is turned off. If you desire to explicitly delete a stored quickcopy job, proceed as follows:Follow steps 1 through 8 in the above section to letthe title of the job to be deleted displayed.When the title of the job to be deleted is displayed,e.g. Report, below, press the ENTER key. The cursorbelow the copy count starts to blink.Press the key repeatedly until Delete appearsbelow the title.Press the ENTER key. The stored quick copy job is de-leted.Using Quick Copye-MPS >>Quick CopyHarold>Quick Copy?Harold>Quick Copy?Arlen1234567>Arlen?Report>ReportCopies 001>ReportCopies 001>ReportDelete89101234