Chapter 1 Using the Operator Panel1-12To use this function, the network interface card must be installedon the printer.You can print out a status page for the option network inter-face. The option network status page shows the firmware ver-sion, the network addresses, and other information undervarious network protocols about the network interface. Thedefault setting is Off (print disabled). When On (print) is se-lected, the option network status page will be output after theprinter status page.Printing out a network interface status page may not be possiblewith some optional network interface cards. For details, see themanual for the network interface.Press the MENU key.Press the or key repeatedly until Interface> appears.Press the ENTER key. A blinking question mark (?)appears.Press the or key repeatedly until Option ap-pears.Press the ENTER key again. The question mark (?)disappears.Press the key and then press the or key re-peatedly until the message display indicates>Opt. StatusPage.The default setting is Off. Change it as follows.Press the ENTER key. A blinking question mark (?)appears.Select On using the or key.Press the ENTER key again.Press the MENU key. The message display returns toReady.Network Status PagePrinting Option Network Status PageNOTENOTEInterface >ParallelInterface? ParallelInterface? OptionInterface >Option>Opt. StatusPageOff123456>Opt. StatusPage? Off>Opt. StatusPage? On>Opt. StatusPageOn78910NETWORK STATUS PAGEPage 1 of 4
