Chapter 1 Using the Operator Panel1-27Press the ENTER key. A blinking question mark (?)appears.Select KPDL or KPDL (AUTO) using the or key.Press the ENTER key.Press the key. The message display changes tothat shown below. If >Alt. Emulation is displayedwhen the KPDL (AUTO) emulation is selected, pressthe or key to change it.Press the ENTER key. A blinking question mark (?)appears.Select On using the or key.Press the ENTER key.Press the MENU key. The message display returns toReady.You can select the default font for the current interface. In ad-dition to the internal fonts, all fonts that are downloaded tothe printer memory, or fonts stored on a memory card or op-tion hard disk can be selected as the default font.You can also set the type and pitch for Courier and LetterGothic.Selecting the Default FontPress the MENU key.Press the or key repeatedly until Font > ap-pears.Press the key to select an internal font, press theor key repeatedly until Internal appears.To select an option font, press the ENTER key while>Font Select > is displayed. Press the orkey repeatedly until the message display indicatesOption. This operation is possible only when optionfonts are installed in the printer.Press the key.The letter before the number indicates the type offont as follows:Press the ENTER key. A blinking question mark (?)appears.Press the or key repeatedly until the desiredfont number appears. For font numbers of the inter-nal fonts, seeList of Fonts on page A-1.Emulation? PCL 6Emulation? KPDL>Print KPDL ErrsOFF>Print KPDL Errs? OFF>Print KPDL Errs? ON345678910Setting Default FontFont >>Font Select >Internal>> I000Letter DescriptionI Internal fontsS Soft (download) fontsM Fonts in an option memory cardH Fonts in a RAM disk or hard diskO Fonts in an option ROM>>?I000123456