Chapter 1 Using the Operator Panel1-23To use this function, the duplexer must be installed on the print-er.Using the optional duplex unit, you can automatically printon both sides of the paper. The duplex unit is installed un-derneath the printer. The default setting of the duplex print-ing is None (duplex printing disabled).Binding SetupsThe term binding refers to the manner in which printed pag-es of paper are joined together (by gluing, stitching, etc.) inbook form. The two possible types of binding are long-edgebinding, in which pages are joined together along their longedge; and short-edge binding, in which they are joined to-gether along their short edge. In selecting a binding type,you must also consider the orientation of the printed page.You can use long-edge or short-edge binding with eitherlandscape or portrait printing.Depending on the binding type and print orientation, the du-plex unit provides four types of binding setups. These are: (1)portrait, long-edge, (2) portrait, short edge, (3) landscape,long-edge, and (4) landscape, short-edge. The figure belowshows these binding setups.To select duplex printing and binding setup from the opera-tor panel, proceed as follows.Press the MENU key.Press the or key repeatedly until PaperHandling > appears.Press the key.Press the or key repeatedly until >DuplexMode appears.Press the ENTER key. A blinking question mark (?)appears.Press the or key to display the desired duplexmode. The display changes as shown below.None (default)Short edge bindLong edge bindWhen the desired duplex mode displayed, press theENTER key.Press the MENU key. The message display returns toReady.Setting Duplex PrintingNOTEPaper Handling >Binding Setups(1) (2)(4)(3)Portrait,short-edgeLandscape,short-edgePortrait,long-edgeLandscape,long-edge123>Duplex ModeNone>Duplex Mode?None45678