Preparation: Mounting the Lens and Performing the Flange Back and White Shading AdjustmentsRaise the lens clamping lever and remove themount cap.To mount the lens, align the indentation at thetop center of the lens mount with the centermark of the lens.Secure the cable through the cable clamp, andplug it into the LENS connector.Adjust the lens flange back.Please refer to the lens instruction manual for guidanceon lens handling.When the lens is removed, install the mount cap toprotect the device.If images are not clearly focused at both telephoto and wide-angle positions during zoom operations, adjust the flangeback (distance from the lens mounting surface to the imageformation surface).Please also refer to the lens instruction manual for directionson adjustment and locations of individual lens parts.Mount the lens on the camera.Make sure you connect the lens cable.Place the flange back adjustment chart about3 m from the lens and adjust the lighting onthe chart to obtain an appropriate videooutput level.If the video level is too high, use the filters or theshutter.Loosen the F.f (Flange focus) ring clampingscrew.F.b (Flange back) may be indicated on some lenses.Set the zoom ring to the telephoto position,either manually or by electric drive.Aim the lens at the flange back adjustmentchart and turn the distance ring to bring thechart into focus.Set the zoom ring to the wide-angle positionand turn the F.f ring to bring the chart intofocus.While focusing, take care not to move the distance ring.Mounting the LensLens ClampingLeverMount CapMarkLENS ConnectorAdjusting the Lens Flange BackApproximately 3mUSO RESTRITO