Recording and Playback: ONE CLIP REC FunctionThis function compiles multiple recordings into a combinedclip and does not isolate single recordings (from RECSTART to STOP) to single clips.Use this function by setting the ONE CLIP REC MODE itemtoON. The menu item ONE CLIP REC MODE is found inthe screen on the SYSTEM SETTINGpage.When the ONE CLIP REC mode is selected,1-CLIPwilldisplay in the lower right of the viewfinder and the LCDmonitor.Start the first recording by pressing the REC button.START1CLIPwill display.Any subsequent recordings are automatically combined intothe clip. Up to a maximum of 99 clips can be combined into asingle clip.Follow the instructions below to use a new and separate clipand end combining to the clip.Press and hold the STOP button for about 2 secondswhile recording is paused. (operating while recording is onstandby)OrPress and hold the REC button for about 2 seconds whilerecording to stop recording. (operating while recording)Follow the instructions above to end combining to the clip.END 1-CLIPdisplays. Subsequent recordings use a newand separate clip.In addition to the aforementioned steps, the following endscombining to the clip and subsequent recordings use a newclip.When the power is turned offWhen the P2 card with the previous recording isremovedWhen the P2 card is formatted or the clip is deleted(when the previous combined clip does not exist)The clip does not stop combining even when the STOPbutton is pressed in the Menu or on the thumbnail display.Pressing the STOP button of the remote control unit (AJ-RC10G) or the extension control unit (AG-EC4G) cannot quitconsolidating clips.Set the ONE CLIP REC MODE item toOFFin the Menu.A text memo can be automatically added to the start of therecording, the start of a section can be cued for playback,and the thumbnail of the location can be checked beforeeach recording.Automatically add a text memo to the start of the recordingby setting the START TEXT MEMO item toON. The menuitem START TEXT MEMO is found in the screen on the SYSTEM SETTING page.Check and playback the location of the added text memo byselecting THUMBNAILTEXT MEMO CLIPS from theThumbnail Menu and moving the cursor over the desiredclip.[Playing back a clip at the position where a text memo isrecorded] (page 124)In addition, cue the location of the text memo for playback bysetting the SEEK SELECT item toCLIP&T. Press the FF orREW button while playback is paused. The menu item SEEKSELECT is found in the SYSTEM SETTING page.ONE CLIP REC FunctionRecording a New Clip* Up to a maximum of 99 recordings can be combined into asingle clip. When the 99th recording ends, recordings are nolonger automatically combined into the same clip. Subsequentrecordings are combined into a new clip.First RecordingNth Recording*REC StartREC stopSingle Combined ClipREC StartREC StartREC stopREC stopExiting ONE CLIP REC modeCueing to the Start of the Combined Section ofthe ClipUSO RESTRITO
