Panasonic AJ-HPX3100G Operating Instructions Manual

Also see for AJ-HPX3100G: Operating instructions Manual 

Contents

Menu: Menu Description TablesItems/Data Saved RemarksSpecify the operation mode of thecamera-recorder when an external deviceis connected via USB.USB HOST:Sets the camera-recorder to the modethat allows an external hard disk driveto be connected.USB DEV.:Sets the camera-recorder to the USBdevice mode, which allows a PC to beconnected via USB 2.0 for use with P2cards as mass storage.FUsed to enable or disable the mode thatallows the camera-recorder to beconnected to a PC or an external harddisk drive via USB 2.0.Sets the camera-recorder to themode selected through the PCMODE SELECT menu option.Disables the PC MODE for normaloperation.Once the power is turned off, the option isalways set to OFF when the power isturned on next time. F OPTION MODEItems/Data Saved RemarksRED: The red tally lamp lights up.GREEN:The green tally lamp lights up.CHAR: The VF displays [REC] incharacters.Setting to “GREEN” or “CHAR” meansthat the front tally lamp, back tally lamp,and rear tally lamp on the unit’sviewfinder will not light up duringrecording. C U F Specify whether or not to enable the P2card access LEDs.The LEDs stay OFF.The LEDs light up. C U F Select whether or not to hold the UMIDGPS position information while the poweris turned off, thereby keeping thisinformation as status data holding theprevious value until the power is turnedon again, which enables a newmeasurement to start.Hold and save the data.Clear the data when the power isturned off, and save zero (No-Info) from the next power-on untila new measurement iscompleted. C U F Used to specify whether or not to outputmetadata (UMID) to SDI. C U F Select whether or not to add an errordetection flag to the SD SDI output. C U F Sets whether or not to use the recordingoperation control function for an externaldevice (recorder etc.) attached to SDIOUT terminal or MON OUT terminal.(output from HD SDI)The display method of thecamera-recorder recording status canbe selected with the REC TALLY item.Recording operation commandscannot be output in INTERVAL RECmode and LOOP REC mode.For supported external devices(recorders etc.), refer to the followingwebsite.http://panasonic.biz/sav/autorec_e/ C U F Select the method for detecting RECSTART/STOP marks from the frame rateinformation in the user bits added throughHD SD IN in HD mode in order toautomatically start or stop recording.OFF: No automatic recording isperformed.TYPE1:REC START/STOP marks aredetected from LTC input throughHD SDI for automatic recording.TYPE2:REC START/STOP marks aredetected from VITC input throughHD SDI for automatic recording.Set the menu option REC SIGNAL to SDIto input HD SDI signals to the SDI INconnector. For information about user bitsframe rate information, see [Setting of theUser bits] (page 64).In INTERVAL REC mode and the LOOPREC mode, the AUTO REC function isnot available. C U F Select the function that automaticallyadds a text memo to the start of therecording before each recording.Add a text memo before eachrecording.Do not add a text memo.When this item is ON, the added textindicates the start of the recording. Referto [Setting of Clip Meta Data] (page 128)to record a text memo as textualinformation. C U F Press the FF/REW buttons whileplayback is paused to move to thelocation.CLIP: Cue to the start of the clipCLIP&T: Cue to the start of the clipand add a text memo C U F Items/Data Saved RemarksUSO RESTRITO