Adjustments and Settings for Recording Viewfinder Screen Status DisplaysThe center, safety zone, safety zone area and framemarkers may be set to ON or OFF, along with specificationsof the marker types. To set and select markers, go to the screen from the VF page and select theappropriate options.For directions on navigating the menu, see [Setting MenuOptions] (page 160).The indication MKR:A at the upper right of the screen showsthe current indication status. To view TABLE B, press theMARKER SEL, MODE CHK / MENU CANCEL switch on the unit.This changes the indication to MKR:B, allowing you to view theset conditions.The viewfinder can display a screen that allows you to viewthe marker settings of the unit.When you press the MARKER SEL, MODE CHK / MENUCANCEL switch on the side of this unit, the markerdisplayed by the viewfinder changes.Marker A Marker B No markerIf the menu item FRAME SIG is set to 16:9 as theinformation of Marker A and 4:3 as the information of MarkerB, then the 16:9 and 4:3 view angles can easily be checkedwith the button, as required. The menu item FRAME SIG isfound in the screen on the VF page.The viewfinder displays the return video signal input to theGENLOCK IN or SDI IN connector while the RET button atthe lens is held down. To enable this function, select CAMRET for the menu option RET SW.In HD (1080i) mode, either the HD SDI signal from the SDIIN connector, or the HD-Y signal from the GENLOCK INconnector in the RETURN SIGNAL item can be selected. InSD mode, only the SD SDI signal from the SDI IN connectorcan be viewed.The menu item RETURN SIGNAL is found in the screen on the SYSTEM SETTING page, andthe menu item RET SW is found in the screenon the CAM OPERATION page.Setting the Marker DisplaysMarker Check Screen Displays (MARKER SELECT button function)MARKER SEL, MODECHK / MENU CANCELswitchCenter markerMarkersSafety zoneThe view angle specified through the menu optionFRAME SIG is displayed.Checking Return Video Signal in the ViewfinderUSO RESTRITO
