Panasonic AJ-SD755 Operating Instructions Manual

11Display panel1 WIDE lampThis lamp lights when 16:9 wide-screen informationis being recorded on a tape.Recording of wide-screen information can beselected on setup menu No. 645 (WIDE SELECT).This lights lamps during tape playback when wide-screen information has been recorded on the tape.2 REMOTE lampThis lamp lights when the CONTROL switch hasbeen set to the REMOTE position.3 INPUT SELECT display areaThe characters corresponding to the selected inputsignals light. With all input signals except for analogaudio signals, the fact that no signals have beenselected is indicated by a flashing display.Y PB PR : Analog component video signalsCMPST : Analog composite video signalsSDI : Serial digital video signals (option)SDTI/1394 : Compressed digital signals (option)SG/SG 1/SG 2 : Internal reference signalsANALOG : Analog audio signalsAES/EBU : Digital audio signalsUSER SET : Recording audio signal selectionSDI : Serial digital audio signals (option)SDTI/1394 : Compressed digital signals (option)SG : Internal reference signalsAUDIOVIDEOParts and their functions2 5 74 63 8CTLANALOGAUDIOUAES/EBUUSER SETSDISDTI/1394SGINHSCHDVCPRODVCAMSERVOEDIT RECTCUB=Y PB PRVIDEOCMPSTSDISDTI/1394SG 1 2REMOTE525dB0- 4- 8- 12- 16- 20- 25- 30-L RdB0- 4- 8- 12- 16- 20- 25- 30-L RdBCUE- 8- 12- 16- 20- 25- 30-L R1WIDE4 lampThis lamp lights when UMID information is presenton the input signal in E-E mode.This lamp lights during tape playback when UMIDinformation has been recorded on the tape.5 SCH lampThis lamp lights when the SCH phase of theexternal synchronized signal (REF VIDEO) is insidethe prescribed range.At all other times, the lamp is off.6 = lampThis lamp lights when a cassette tape is insertedinto the VTR.In the standby OFF mode, this lamp is flashing.7 SERVO lampThis lamp lights when the drum servo or capstanservo locks.8 Channel condition lampsThese lamps light to indicate the error rate status.(green 5 white 5 red)Green : This lights when the error rates for the videoand audio playback signals are both atacceptable levels.White : This lights when the error rate for the videoor audio playback level has increased.The playback picture and sound remainunaffected even while this lamp is lighted.Red : This lights when the error rate for the videoor audio playback level has increased to theextent that correction or interpolation wasperformed.U