Panasonic AJ-SD755 Operating Instructions Manual

61A B C D E F G H2 Attach the outer member brackets to the rack.Check that the height is the same for the left andright brackets.3 Remove the four screws at the front for attachingthe left and right side panels.4 Attach the AJ-MA75P rack mount adapter usingthe same 4 screws.1 Attach the inner members of the slide rails.Refer to the figure below for the locations wherethe screws are to be attached.The unit can be mounted into a 19-inch standard rackusing the optional rack-mounting adaptors (AJ-MA75P). For the installation rails, it is recommendedthat the 18-inch rail and bracket (model numberCC3061-99-0400) by Chassis Trak be used. (Thecomplete slide rail and bracket unit is not availablefrom Panasonic.)For further details, consult your dealer.Rack mountingO The length of the screws used is subject torestriction. (B, G: 10 mm, E: 6 mm)O Attach the inner members at the samesymmetrical positions on the left (L) side.O Fix the members in place using 3 screws oneach side (total: 6 screws).O The letters “A” to “H” are not actually marked onthe side panels.Inner memberLocations where the screws are secured on the right(R) side of the inner members of the slide railsRack-mounting adaptors5 Remove the 4 rubber legs from the bottom of theunit, and install the unit in the rack.After the unit has been installed, check that itmoves smoothly along the rails.Standard rackFasten it to the rack with setscrews.O Keep the temperature inside the rack to between41°F to 104°F (5°C to 40°C).O Bolt the rack securely to the floor so that it will nottopple over when the VTR is drawn out.