Panasonic AU-EVA1E Operating Instructions Manual

Contents

– 129 –Chapter 5 Shooting — Audio inputAudio inputThe camera can record two channels of audio.The audio to input to each channel can be switched to the built-in microphone, an external microphone, or a connected audio device.Switching the audio inputr Audio recording formatThe audio recording format such as compression format varies depending on the recording mode.Recording mode Recording format Sampling rate/bitMOV Linear PCM (LPCM) 48 kHz/24 bitAVCHD Dolby Audio TM 48 kHz/16 bitr Selecting audio input signalsThe recorded input signal varies depending on the [AUDIO SETTINGS] menu → [AUDIO CH SETTINGS] → [CH1 IN SELECT]/[CH2 IN SELECT]setting.Item Input signal to be recorded[CH1 IN SELECT] [CH2 IN SELECT] Audio channel 1 Audio channel 2[INT(L)] [INT(R)] Built-in microphone Built-in microphone [INPUT1] Built-in microphone

[INPUT2] Built-in microphone

[INPUT1] [INT(R)]

Built-in microphone [INPUT1]

[INPUT2]

When using the built-in microphone1 Select the [AUDIO SETTINGS] menu → [AUDIO CH SETTINGS] → [CH1 IN SELECT] → [INT(L)].2 Select the [AUDIO SETTINGS] menu → [AUDIO CH SETTINGS] → [CH2 IN SELECT] → [INT(R)].@@ NOTEt To decrease the wind noise of the microphone, select the [AUDIO SETTINGS] menu → [AUDIO CH SETTINGS] → [CH1 MIC LOWCUT]/[CH2 MICLOWCUT] → [ON].When using an audio device or an external microphone1 Connect an audio device or an external microphone to the

2 Set each item in the [AUDIO SETTINGS] menu → [AUDIO INPUT].Connected device[AUDIO INPUT][INPUT1 LINE/MIC SEL]/[INPUT2 LINE/MIC SEL][INPUT1 MIC POWER]/[INPUT2 MIC POWER][INPUT1 MIC LEVEL]/[INPUT2 MIC LEVEL]*1[INPUT1 LINE LEVEL]/[INPUT2 LINE LEVEL]*2Audio device [LINE] Disabled Disabled [4dB], [0dB]External microphone [MIC] [OFF] [-40dB], [-50dB], [-60dB] DisabledExternal microphone (withpower supply)[MIC] [ON] [-40dB], [-50dB], [-60dB] Disabled*1 Factory setting: [-60dB]*2 Factory setting: [4dB]@@ NOTEt When using a super-directional microphone AG-MC200G (optional), set [INPUT1 MIC LEVEL]/[INPUT2 MIC LEVEL] to [-50dB].Adjusting the audio recording levelThere are manual adjustment and automatic adjustment as the adjustment method of the audio recording level.Automatic adjustment of the recording level1 Set the / switch to .f Audio channel 1 and audio channel 2 can individually set.f Following settings are disabled when the / switch is set to .- Adjustment of the recording level by the

- The [AUDIO SETTINGS] menu → [AUDIO CH SETTINGS] → [CH1 LIMITER]/[CH2 LIMITER] setting