Panasonic AU-EVA1E Operating Instructions Manual

Contents

– 83 –Chapter 4 Operation — Menu setting contentsMinute [00]…[59]Second [00]…[59]Frame [00] … [23] (when [24.00p] or [23.98p] is set)[00] … [24] (when [50.00i], [50.00p], or [25.00p] is set)[00] … [29] (when [59.94i], [59.94p], or [29.97p] is set)(Factory setting: [00]) (each item)[SET UB]Sets user bits.Enabled only when [USER] is selected in [UB MODE] of [TC].Each digit can be set in following range.f [00]…[FF](Factory setting: [00])[TC/UB/Dur.]Switches the time code display to the user bits or duration counter display.The items that can be set are as follows.[TC] Time code display[UB] User bits display[Dur.] Duration counter display(Factory setting: [TC])[FREE/REC RUN]Sets the operation mode to advance the time code generator.[FREE RUN] Advances regardless of the operation mode.[REC RUN] Advances only while recording.(Factory setting: [FREE RUN])@@ NOTEt It will be fixed to [REC RUN] when the [CAMERA SETTINGS] menu → [FPS] → [VFR SW] → [ON] is set.t It will be fixed to [FREE RUN] when the [REC SETTINGS] menu → [PRE REC] → [ON] is set.[DF/NDF]Sets the count method for the time code generator.Enabled only when the [SYSTEM SETTINGS] menu → [SYSTEM MODE] → [FREQUENCY] → [59.94i]/[59.94p]/[29.97p] is set.[DF] Uses the drop frame mode.[NDF] Uses the non-drop frame mode.(Factory setting: [NDF])[UB MODE]Selects the user bits mode. User bits information is recorded in the clip. Also, it is output as LTC UB, VITC UB of the SDI signal.[FRAME RATE] Selects the image information (such as frame rate) of the camera.[USER] Selects the user bits set in [SET UB].[TIME] Selects the local time. (hh, mm, ss)[DATE] Selects the local date and time. (YY, MM, DD, hh)[CLIP NAME] ASCII character code of the CAM INDEX (A to Z) recorded as a MOV format file goes into MSB. Also, three digit ASCIIcharacter code of the REEL COUNT recorded as the MOV format file goes into LSB. (Example: A123=0x41 0x31 0x32 0x33)It will record even if the [SYSTEM SETTINGS] menu → [SYSTEM MODE] → [MAIN CODEC] is not set to the MOV format.(Factory setting: [USER])[TC IN/OUT SEL]Sets the input/output of the terminal.[TC IN] Sets to the time code input.[TC OUT] Sets to the time code output.(Factory setting: [TC IN])[TC OUT REF]Sets the output delay of the time code that is output from the terminal.[RECORDING] Outputs the recording time code without delay. This is used when performing simultaneous recording on two cameras withthe time code of this camera as the master.[SDI OUT] Matches to output image from the terminal. Outputs without delay when video is not output from the terminal.(Factory setting: [RECORDING])