23.3.3 UM Configuration—[4-3] Service Settings—CustomService—Time ControlThe below parameters are set for the Time Control Custom Service in the Custom Service Builder.This service allows you to assign a different operation for up to 5 blocks of time during the day. The callermakes no selection and no menu is announced.DescriptionThe information typed in this field is for reference only.Value RangeMax. 32 charactersMaintenance Console Location23.3.3 UM Configuration—[4-3] Service Settings—Custom Service—Time ControlFeature Guide References3.2.1.15 Custom ServicePeriod 1–5, OutsidePeriod 1–5:Specifies the name of time period for reference, start and end time, and an operation.NoteWhen the start time is specified and the end time is "None", the period will end at "00:00".Outside:Allows you to specify an operation that is enabled for all other times not included in the set time periods.Value RangePeriod 1–5:Name: Max. 16 charactersFrom/To: Select the check box, click the input field, and then specify a time (hour and minute). You can specifya beginning time (From), ending time (To), or both for each period.Assigned Operation: Trf to Mbx, Trf to Ext, Operator, Trf to Out, Exit, Prev Menu, CS, VM Serv, Call Trf Serv,Subscriber Serv, Dial by Name, Repeat Menu, Main Menu, Trf to Fax Extn, List All Names, Fax Service,None (see 23.3.1 UM Configuration—[4-3] Service Settings—Custom Service—Menu & Transfer—Key – Assigned Operation: 0–9, *, #)Outside:Name: Max. 16 charactersAssigned Operation: Trf to Mbx, Trf to Ext, Operator, Trf to Out, Exit, Prev Menu, CS, VM Serv, Call Trf Serv,Subscriber Serv, Dial by Name, Repeat Menu, Main Menu, Trf to Fax Extn, List All Names, Fax Service,None (see 23.3.1 UM Configuration—[4-3] Service Settings—Custom Service—Menu & Transfer—Key – Assigned Operation: 0–9, *, #)PC Programming Manual 94523.3.3 UM Configuration—[4-3] Service Settings—Custom Service—Time Control
