23.3.5 UM Configuration—[4-3] Service Settings—CustomService—PasswordThe below parameters are set for the Password Custom Service in the Custom Service Builder.This service requires that callers enter a password, followed by "#". Each password is assigned an operation.If a password is entered correctly, the caller is handled by the password’s pre-programmed operation. Theprompt for this service can be recorded in the CS No. dialogue box.Custom Service prompts can be recorded only in On-line mode.DescriptionThe information typed in this field is for reference only.Value RangeMax. 32 charactersMaintenance Console Location23.3.5 UM Configuration—[4-3] Service Settings—Custom Service—PasswordFeature Guide References3.2.1.15 Custom ServiceMenu Repeat Cycle (1-3)Specifies the number of times the Custom Service menu message will be repeated to the caller.Value Range1–3 timesMaintenance Console Location23.3.5 UM Configuration—[4-3] Service Settings—Custom Service—PasswordFeature Guide References3.2.1.15 Custom ServiceWait for First Digit (0-10 s)Specifies the length of time that the system waits for the caller to dial the first digit after a Custom Service menuis played for the caller. If this time expires, the No DTMF Operation setting determines how the call is thenhandled.Value Range1–10 sMaintenance Console Location23.3.5 UM Configuration—[4-3] Service Settings—Custom Service—Password948 PC Programming Manual23.3.5 UM Configuration—[4-3] Service Settings—Custom Service—Password
