Panasonic Lumix DC-TZ220D Operating Instructions Manual

290OthersQ&A Troubleshooting■ Wi-Fi functionA Wi-Fi connection cannot be established. Radio waves get disconnected. Wireless accesspoint is not displayed.General tips for using a Wi-Fi connection• Use within the communication range of the wireless LAN network.• Is any device, such as microwave oven, cordless phone, etc., that uses 2.4 GHz frequencyoperated nearby?→ Radio waves may get interrupted when used simultaneously. Use them sufficiently away fromthe device.• When the battery indicator is flashing red, the connection with other equipment may not start or theconnection may be disrupted. (A message such as [Communication error] is displayed.)• When this unit is placed on a metal table or shelf, the connection may not be established easily.Use the camera away from metal surfaces.About a wireless access point• Check if the wireless access point to connect is in operating state.• Check the radio wave condition of the wireless access point.→ Perform the connection closer to the wireless access point.→ Move the location or change the angle of the wireless access point.• It may not display even if the radio waves exist depending on the setting of the wireless accesspoint.→ Turn off the wireless access point and then turn it back on.• Is the network SSID of the wireless access point set not to broadcast?→ It may not be detected when it is set not to broadcast. Enter and set the network SSID. (→255)Alternatively, set the network SSID of the wireless access point to broadcast.This unit is not displayed in the Wi-Fi setting screen of the smartphone.• Try switching the ON/OFF of the Wi-Fi function in the Wi-Fi settings of the smartphone.