15 PreparationRemote control unitq Power indicator(pages 27, 28 and 45)This indicator illuminates red whenthe MAIN POWER switch is turnedon (standby mode), and illuminatesgreen when the power is turned onand a picture starts to be projected.When the WEB STANDBY is setto "ON", the cooling fan operatesand the power indicator on theprojector flashes slowly in red.w RGB INPUT indicator(page 55)This indicator shows whether asignal is being input to the RGBinput connectors (RGB 1 IN/RGB2 IN). When an input signal isdetected, the indicator illuminates.e LAMP indicator(page 50)This indicator illuminates when it istime to replace the lamp unit. It flashesif a circuit abnormality is detected.r Input select (INPUT, RGB,VIDEO) buttons(page 27)t TEMP indicator(page 49)This indicator illuminates if anabnormally high temperature isdetected inside the projector oraround it. If the temperature risesabove a certain level, the powersupply will be turned offautomatically and the indicatorwill illuminate or flash.y POWER button(pages 27 and 28)u AUTO SETUP button(pages 27 and 55)If this button is pressed while apicture is being projected, theprojection settings will beadjusted automatically inaccordance with the signal beinginput. In addition, the angle of tiltof the projector will beautomatically detected andadjusted in order to correct anykeystone distortion. (“AUTOSETUP” will appear on thescreen during adjustment.) SetSHUTTERPOWER AUTO SETUP INPUTTEMPLAMPRGB INPUTENTERMENUON(G)STANDBY(R)POWERRGBVIDEOR-CLICKLASERMENUPAGEENTERFREEZE SHUTTERFUNC1Computer Pro jectorSTDSETUPAUTOyru!6!7o!5!0!1!8 i@4!9@0@1@3!2y!3 !4utrewo !0 !1iqProjector control panel