8Do not look into the lens while the projector is being used.• Strong light is emitted from the projector’s lens. If you look directly into thislight, it can hurt and damage your eyes.Do not bring your hands or other objects close to the air outlet port.• Heated air comes out of the air outlet port. Do not bring your hands or face,or objects which cannot withstand heat close to this port, otherwise burnsor damage could result.When replacing the lamp, allow it to cool for at least one hour beforehandling it.• The lamp cover gets very hot, and contact with it can cause burns.Before replacing the lamp, be sure to unplug the power cord from thepower outlet.• Electric shocks or explosions can result if this is not done.Keep the SD memory card out of the reach of infants.• If the memory card is swallowed, death by suffocation may result. If youbelieve that the memory card may have been swallowed, seek medicaladvice immediately.CautionDo not cover the air inlet or the air outlet.• Doing so may cause the projector to overheat, which can cause fire ordamage to the projector.Do not set up the projector in humid or dusty places or in places wherethe projector may come into contact with smoke or steam.• Using the projector under such conditions may result in fire or electricshocks.When disconnecting the power cord, hold the plug, not the cord.• If the power cord itself is pulled, the cord will become damaged, and fire,short-circuits or serious electric shocks may result.Always disconnect all cables before moving the projector.• Moving the projector with cables still attached can damage the cables,which could cause fire or electric shocks to occur.Do not place any heavy objects on top of the projector.• Failure to observe this may cause the projector to become unbalanced andfall, which could result in damage or injury.Do not short-circuit, heat or disassemble the batteries or place theminto water or fire.• Failure to observe this may cause the batteries to overheat, leak, explodeor catch fire, and burns or other injury may result.When inserting the batteries, make sure the polarities (+ and -) arecorrect.• If the batteries are inserted incorrectly, they may explode or leak, and fire,injury or contamination of the battery compartment and surrounding areamay result.