54o Press the ENTER button andselect the “LAMP RUN TIME” bypressing the or buttons.!0 Press and hold the ENTERbutton for approximately 3seconds.The “Lamp Time Reset” will bedisplayed.!1 Select “OK” by pressing theor buttons and press theENTER button.NOTE:• If “CANCEL” is selected in step!0, the operation for resetting thelamp time will be cancelled.!2 Turn off the power.This will reset the cumulativeusage time for the lamp unit tozero.Refer to steps e and r on page28 for details on how to turn offthe power.t Install the lamp unit cover, andthen use a Phillips screwdriverto securely tighten the lampunit cover fixing screws.NOTE:• Be sure to install the lamp unitand the lamp unit cover securely.If they are not securely installed, itmay cause the protection circuit tooperate so that the power cannotbe turned on.y Insert the power cord plug intothe wall outlet and then pressthe MAIN POWER switch.NOTE:• If the POWER indicator on theprojector does not illuminate redwhen the MAIN POWER switch isturned on, turn the MAIN POWERswitch off again and check thatthe lamp unit and the lamp unitcover are securely installed. Thenturn the MAIN POWER switchback on.u Press the POWER button sothat a picture is projected ontothe screen.i Press the MENU button todisplay the MENU screen, andselect “OPTION” by pressingthe or buttons.OPTIONSHUTTERINPUT DISPAUTO KEYSTONERGB/YPbPrAUTO RGB INRGB2 SELECTBACK COLORFRONT/REARDESK/CEILINGLAMP POWERLAMP RUN TIMENEXT PAGE ↓1820 HOFFOFFRGBOFFINPUTBLUEFRONTDESKLOWONONYPbPrONOUTPUTBLACKREARCEILINGHIGHSELECT:[↑][↓] ENTER:[ENTER]ESC :[MENU]OPTIONSHUTTEROSDAUTO KEYSTONERGB/YPbPrAUTO RGB INRGB2 SELECTBACK COLORFRONT/REARDESK/CEILINGLAMP POWERLAMP RUN TIMENEXT PAGE ↓1820 HOFFOFFRGBOFFINPUTBLUEFRONTDESKLOWONONYPbPrONOUTPUTBLACKREARCEILINGHIGHSELECT:[↑][↓] ENTER:[ENTER]ESC :[MENU]Power OFFOK CANCELLamp Time Reset