36Color Hue Setting (colortemperature)This is used to adjust the whiteareas of the picture if they appearbluish or reddish.COLOR(S-VIDEO/VIDEO/YPB PR only)Press the button to make thecolor more vivid in tone, and pressthe button to make the colormore pastel in tone.TINT(NTSC/NTSC 4.43/YPBPR only)This adjusts the flesh tones in thepicture. Press the button tomake flesh tones more greenish,and press the button to make theflesh tones more reddish.BRIGHTThis adjusts the darker areas (blackareas) in the picture. Press thebutton if dark areas are too solid (forexample, if hair is difficult to see), andpress the button if black areas aretoo light (grey rather than black).CONTRASTThis adjusts the contrast of thepicture. Press the button tomake the picture brighter, and pressthe button to make the picturedarker. (Adjust the BRIGHT settingfirst if required before adjusting theCONTRAST setting.)SHARPNESSPress the button to make thepicture details sharper, and pressthe button to make the picturedetails softer.STANDARDHIGHLOWSTANDARDHIGHLOWNoise Reduction (NR)(When S-VIDEO/VIDEO/YP BPRsignals are being input)If the signal is of such poor qualitythat picture interference appears, youcan suppress this interference byadjusting the NR (Noise Reduction),except for 750p (720p), HDTV60(1080i/60) and HDTV50 (1080i/50)signals. To strengthen the effect,press the button. To turn it off ,set to “0” by pressing the button.TV SYSTEM(S-VIDEO/VIDEO only)AUTO1 The projector automaticallydistinguishes between NTSC/NTSC4.43/PAL/PAL60/SECAM signals.AUTO2 The projector automaticallydistinguishes between NTSC/PAL-M/PAL-N signals.NOTE:• This should normally be set to“AUTO1” or “AUTO2”. If the signalis of such poor quality that thecorrect format cannot beautomatically distinguished,change the setting manually to therequired TV system.AUTO1AUTO2NTSCNTSC4.43PALPAL-MPAL-NSECAM