27 Basic OperationPOWERRGBVIDEOLASERMENUPAGESETUPAUTOSHUTTERPOWER AUTO SETUP INPUTTEMPLAMPRGB INPUTENTERMENUON(G)STANDBY(R)Starting to useTurning on the powerPlease ensure that all preparations have been completed before turning onthe power. (Refer to pages 22 – 26.)wePOWERRGBVIDEOLASERMENUPAGESETUPAUTOSHUTTERPOWER AUTO SETUP INPUTTEMPLAMPRGB INPUTENTERMENUON(G)STANDBY(R)POWERRGBVIDEOLASERMENUPAGESETUPAUTOSHUTTERPOWER AUTO SETUP INPUTTEMPLAMPRGB INPUTENTERMENUON(G)STANDBY(R)q Remove the lens cover.w Connect the accessory power cord.e Press the MAIN POWER switch tothe “|” side to turn on the power.The power indicator on the projectorwill illuminate red.r Press the POWER button.The power indicator on the projectorwill flash green. After a short period,the indicator will illuminate green, anda picture will be projected.t Press the input select (INPUT, RGB,VIDEO) button to select the inputsignal.The input signal selected will changeas shown at below each time an inputselect button is pressed.y While pressing the adjuster buttons,adjust the forward/back angle of tiltof the projector.INPUT RGBVIDEOS-VIDEOVIDEOSD CARDNETWORKRGB2RGB1SD CARDNETWORKRGB2RGB1S-VIDEOVIDEOu Press the AUTO SETUP button toinitiate automatic positioning.The automatic positioning is only for verticalkeystone distortion. To correct the horizontalkeystone distortion or when keystone distortion hasnot been corrected to the optimum level, carry outthe keystone correction as described on page 39.
