Panasonic PT-VW435NU Operating Instructions Manual

Also see for PT-VW435NEA: Service manual

Contents

Panasonic PT-VW435NU Operating Instructions Manual Manual pdf 17 page image

Precautions for UseENGLISH - 17 ImportantInformationNotes on Using Wireless ConnectionWireless connection function of the projector uses radio waves in the 2.4 GHz band.A radio station license is not required, but be sure to read and fully understand the following items before use.Do not use near other wireless equipment. The following equipment may use radio waves in the same band as the projector.When the projector is used near these devices, radio wave interference may make communication impossible,or the communication speed may become slower.Microwave ovens, etc.•Industrial, chemical and medical equipment, etc.•In-plant radio stations for identifying moving objects such as those used in factory manufacturing lines, etc.•Designated low-power radio stations•If at all possible, avoid the use of cellular phones, TV sets or radios near the projector. Cellular phones, TV sets, radios and similar devices use different radio bands from the projector, so thereis no effect on wireless communication or the transmission and reception of these devices. However, radiowaves from the projector may produce audio or video noise.Wireless communication radio waves cannot penetrate steel reinforcements, metal,concrete, etc.Communication is possible through walls and floors made from materials such as wood and glass (exceptglass containing wire mesh), but not through walls and floors made from steel reinforcements, metal,concrete, etc.Avoid using the projector in locations prone to static electricity. If the projector is used in a location prone to static electricity, such as on a carpet, the wireless LAN or wiredLAN connection may be lost.“Glossary” (Æpage 117 – 118)If this happens, eliminate the source of static electricity or electromagnetic noise and reconnect to thewireless LAN or wired LAN.In rare cases static electricity or electromagnetic noise may make it impossible to establish a connection tothe LAN.If this happens, press the power button on the remote control or on the projector to power off the projectortemporarily.After the cooling fan stops operating (after indicator on the projector changes fromblinking in orange to lighting in red), power on the projector and reconnect to the LAN.Using the projector outside the country It is forbidden to take the projector outside the country or region where you purchased it, so use it only inthe said country or region. Also, note that depending on countries or regions there are restrictions on thechannels and frequencies at which you can use the wireless LAN.Available wireless LAN channels The channels (frequency range) that can be used differ according to the country or region. Refer to the table below.Country or region Standard Channels used Frequency band(Center frequency)England, Germany, France, Spain,Italy, Belgium, Austria, Sweden, Norway,Denmark, Switzerland, Holland, Finland,Portugal, Greece, Thailand, South KoreaETSI 300.3281 – 13 2,412 MHz -2,472 MHzSingapore IDAAustralia, New Zealand C-TickMalaysia SIRIMUnited States FCC part 151 – 11 2,412 MHz -2,462 MHzTaiwan DGT