ENGLISH - 67 SettingsNetworkSelect [Setting] from the Main Menu (see“Navigating through the menu” on page 42),then select the item from the sub-menu.Remote Control Control PanelVerifying the network informationWhen connecting the projector via the dedicatedapplications of "Wireless Manager mobile edition 6.0”or iPad / iPhone / iPod touch, the network number, theproject name and ID of Wireless LAN are required.You can check these information by entering [InputGuide] or [Network Status]. (Æpage 72)To display the input guide, please press the [INPUT]button on the control panel or any one of the inputselection buttons on the remote control.Wired LANYou can make detailed wired LAN settings.Press ▲▼ to select [Wired LAN], and1 )press button.Press ▲▼ to select an item, and2 )change the setting according to theinstructions.DHCP(DHCP clientfunction)On: If a DHCP serverexists in thenetwork to whichthe projector isconnected, theIP address willautomatically beacquired.Off: If a DHCPserver doesnot exist in thenetwork to whichthe projectoris connected,additionally set[IP address],[Subnet mask] and [ Defaultgateway ].IP address(Display of IPaddress and setting)Enter the IP addressif DHCP server is notused.Subnet mask(Displaying andsetting the subnetmask)If not using a DHCPserver, enter the subnetmask.Default gateway(Display of gatewayaddress and setting)Enter the gatewayaddress if DHCP serveris not used.DNS1(Display ofPreferred DNSserver addressand setting)Enter the DNS serveraddress if DHCP serveris not used.DNS2 (Displayof Alternate DNSserver addressand setting)Enter the alternate DNSserver address if DHCPserver is not used.“Glossary” ( Æpage 117– 118)Press ▲▼◄► to select [Set], and press3 ) button.Default wired LAN settingszThe following settings are set before theprojector leaves the factory.DHCP OffIP address 192.168.10.100Subnet mask 255.255.255.0Default gateway 192.168.10.1DNS 1 / DNS 2 NONEInput GuideNetwork number of wireless LAN(Left) Projector name(Right) Projector ID