|
Setting62 - ENGLISHSettingsExecuteJPress ▲▼ to select one among the1 )items as below and then press the button.Start It executes the count up or countdown function.* 1Reset Reset the P-timer values.* 2Exit To exit the P-timer operation.Press the button at Start and the*1 :indication changes into Stop. To stop Count up orCount down, press the button at Stopon the screen menu, then the indication changesinto Restart. Press the button atRestart to resume Count up or Count down.Press the button at Reset to return to*2 :the following value:Count up "000:00"Count down Timer that you setAttentionTo stop the [P-timer] function, press the zbutton.To cancel the [P-timer], press and hold the zbutton for a few seconds.Closed caption[Only for NTSC, 480i input]Press ▲▼ to select [Closed caption].1 )Press ► or the button to2 )enter the submenu.Closed captionJPress ▲▼ to select [Closed caption]1 )and then press the button.Press ▲▼ to select [Off], [CC1], [CC2],2 )[CC3] or [CC4].ColorJPress ▲▼ to select [Color] and then1 )press the button.Press▲▼ to select [Color] or [White].2 )AttentionThe closed caption is mainly used in the north America.zThis function shows the text information contained in theimage signal. Captions may not be displayed on somedevices or software.You can select [Closed caption] when [NTSC] or [480i]zsignals are input.Part of characters may not displayed when highzcompensation values are set in [Keystone].Closed captions are not displayed while the menu screenzappears.Lamp powerThis function allows you to change brightness of thescreen.Press ▲▼ to select [Lamp power] and1 )then press the button .Press ▲▼ to select one among the2 )modes as below.You can also press the button tozdisplay [Lamp power].Normal Normal brightness.EcoLower brightness reduces thelamp power consumption andextends the lamp life.NoteIf [Lamp power] is set to [Normal] and the operatingzenvironment temperature exceeds 35°C(95 °F), [Lamppower] may be changed to [Eco] automatically.Remote controlThis switching function prevents remote controlinterference when operating several projectors orvideo equipment at the same time.Press ▲▼ to select [Remote control].1 )Press ► or the button.2 )Press ▲▼ to select one among the3 )seven codes.This projector provides 7 different remotezcontrol codes: [ALL], [Code 1]~[Code 6].AttentionWhen operating the projector under [ALL] code, you canzoperate several projectors at the same time. If you wantto operate the projector independently, you must switchto other code.When different codes are set on the projector and on thezremote control, any operation cannot be made. In thatcase, switch the code on the remote control to fit thecode on the projector.If the batteries are removed from the remote control for azlong period of time, the remote control code will be reset.
|
