Image adjustENGLISH - 53 SettingsSharpnessPress ▲▼ to select [Sharpness].1 )Press the button to display2 )the adjustment dialog box.Press ◄► to adjust the setting value.3 )Operation Adjustment AdjustmentrangePress ►.increase thesharpness of theimageMaximumvalue 15Press ◄.decrease thesharpness of theimageMinimumvalue 0When [Daylight View] is set to [On] or [Auto], thez[Sharpness] is disabled.GammaPress ▲▼ to select [Gamma].1 )Press the button to display2 )the adjustment dialog box.Press ◄► to adjust the gamma value3 )to obtain a better balance of contrast.Adjustments can be made betweenz 0 and 15.Noise reductionPress ▲▼ to select [Noise reduction].1 )Press the button to display2 )the adjustment dialog box.Press ◄► to select the desired item.3 )Off DisabledL 1 Lower reductionL 2 Higher reductionNoise interference on the screen can bezreduced. Select one of the above options to getsmoother images.[Noise reduction] cannot be selected whenz[480p], [576p], [720p], [1 035i] or [1 080i] isselected.NoteWhen input video signal to the projector, [Noisezreduction] will become available.ProgressivePress ▲▼ to select [Progressive].1 )Press the button to display2 )the dialog box.Press ◄► to select the desired item.3 ) An interlaced video signal can be displayed inzprogressive mode. Select one of the followingoptions.[Progressive] cannot be selected when [480p],z[576p], [720p], [1 035i] or [1 080i] is selected.Off DisabledL 1 For an active pictureL 2 For a still pictureFilm For watching a filmNoteWhen input video signal to the projector, [Progressive]zwill become available.ResetTo reset the adjusted data, all adjustments will returnto their previous figures.Press ▲▼ to select [Reset].1 )Press the button.2 ) A confirmation box appears and then select [Yes].zNoteTo reset the adjusted data except [z Daylight View].StorePress ▲▼ to select [Store].1 )Press ► or the button.2 )Press ▲▼ to select one from Image 13 )to 4 and press the button.A confirmation box appears and then select [Yes].zNoteTo store the adjusted data except [z Daylight View].Make sure you selected [Store] after adjustingzsettings. Some settings can not be stored if notregistered with [Store] function.
