Setting60 - ENGLISHSettingsLogo PIN code changeJLogo PIN code can be changed to your desired four-digit number.Press ▲ ▼ to select [Logo PIN code1 )change] and press the button.Current logo PIN code dialog box appears.zPress ▲▼ to enter the current code,2 )press the ► button to fix the numberand move the red frame pointer to thenext box.The New Logo PIN code input dialog boxzappears.Repeat this step to set the new Logo3 )PIN code.AttentionBe sure to note the new Logo PIN code and keep it onzhand. If you lost the number, you could no longer changethe Logo PIN code setting.HDMI setupThis function is only used for HDMI input source.Press ▲▼ to select [HDMI setup].1 )Press ► or the button.2 ) The names for the output setting of Digital R/G/zB vary from equipment to equipment.ImageJNormal When the output of Digital R/G/Bequipment is set to Standard.Enhanced When the output of Digital R/G/Bequipment is set to Enhanced.SoundJHDMI When Digital input source is input,Sound is set to HDMI.Computer2When DVI input source is changedto HDMI input source, Sound is setto Computer 2.AttentionFor details, refer to the operating instructions of yourzDigital R/G/B equipment.Connect the computer 2 audio input signals tozCOMPUTER AUDIO IN 1 terminal as Sound function isset to Computer 2 and MIC function is turned on.USB terminalPress ▲▼ to select [USB terminal] and1 )then press the button.Press ▲▼ to choose the desired item.2 )Display To display the image when theinput source comes from the USBterminal.MousecontrolTo use the remote control as amouse control.PointerYou can emphasize a part of the projected image withthis function.Press ▲▼ to select [Pointer].1 )Press ► or the button to2 )access the submenu.Press ▲▼ to choose one item among3 )the items such as the size of Spotlight(Large/Middle/Small) and the pattern ofPointer (Arrow/Fingertip/Dot).NoteWhen the pointer displays on the screen, you can usezthe button on the remote controlto move the pointer.TerminalThe COMPUTER 2 IN/MONITOR OUT terminal onthe back of the projector is switchable for computer 2input or monitor output.Press ▲▼ to select [Terminal] and1 )then press the button.Press ▲▼ to switch the item.2 )Computer 2 Computer inputMonitor out Monitor outNoteTerminal function is not available when selectingz[Computer 2] to the input source. Change the inputsource to the others (HDMI, Computer 1, Video, S-Video)so that the Terminal function will be available.
