SettingENGLISH -57SettingsJFocus assist[Focus assist] function is available when it is set to[On]. Then press the button on theremote control or the button on thecontrol panel, [Please wait...] appears, the adjustmentstarts. A test pattern for focus assist appears on thescreen, and a focus assist bar appears in the lowercenter of the screen. Rotate the focus ring to adjustthe focus until the color which displays in the barchange to blue. Then get the clearest image.(Æpages 34-35)NoteThe focus assist bar will display different colors accordingzto the clarity of image. It turns red when you are rotatingthe focus ring to the wrong direction. If it turns yellow itmeans that you are adjusting the focus correctly. Blue isthe optimal adjustment.JScreen fit[Screen fit] function allows you to optimize the imagesize to the screen and correct the keystone distortioneven when projecting from the diagonal to the screen.[Screen fit] function is available when it is set to [On 1]or [On 2]. Then press the button on theremote control or the button on thecontrol panel, [Please wait...] appears, the adjustmentstarts. It will not stop until the projected imagecoincide with screen completely. (Æpages 34-35)On 1The aspect ratio of image will changeto fit the screen.On 2The aspect ratio of image will notchange, and no image area willappears in top/bottom sides or left/rightsides.Note[Keystone (Standard)] will be executed when the camerazwindow cannot identify the state of screen.JColorboardAt the time of simple projection on the colored wall,you can get the close color image to the color imageprojected on a white screen.[Colorbord] function is available when it is set to [On].Then press the button on the remotecontrol or the button on the controlpanel, [Please wait...] appears, the adjustment starts.The [Red], [Green], [Blue] value will change accordingto the color of the screen.Note[Input search], [Auto PC adj.], [Focus assist], [Screen fit]zand [Colorboard] cannot be set [Off] at the same time.BackgroundSelect the background screen for when no input signalis detected.Press ▲▼ to select [Background].1)Press the 2)Press ▲▼ to switch3)between eachoption as below.BlueBlue colored background.UserThe logo transferred by “LogoTransfer Software *1” is projected.BlackBlack colored background.“Logo Transfer Software” is included on the*1:supplied CD-ROM.DisplayThis function decides whether to display On-ScreenDisplays.Press ▲▼ to select [Display].1)Press the 2)Press ▲▼ to switch3)between eachoption as below.OnShow all the On-Screendisplays. *1CountdownoffShow the input image insteadof the countdown when turningon the projector. *2OffHide the On-Screen Displays.*3Use this function when you want to project*1:images after the lamp becomes bright enough.The factory default setting is in this option.Use this function when you want to project the*2:image as early as possible even when the lampis not bright enough.Hide the On-Screen Displays except;*3:● On-Screen Menu● [Power off?]● [P-timer] display● No signal for [Power management]● [Please wait ...]●Arrows for the [True] function in the ScreenMenu
