LAMP REPLACE and WARNING IndicatorsENGLISH - 65 MaintenanceLAMP REPLACE and WARNING IndicatorsManaging the indicated problemsIf a problem should occur inside the projector, the , and/or indicatorswill inform you. Manage the indicated problems as follow.CAUTIONBefore you take a remedial measure, follow the procedure of switching the power off indicated in “Turning off the projector”.z(Æpage 33)If multiple indicators light or blink, verify the status of the projector by looking at each indicator.zNoteConfirm the status of the power indicated on the indicator.zJ LAMP REPLACE indicatorIndicator Lighting in yellowStatus The projection lamp reaches its end of life.Check Is there a Lamp replacement icon appears on the screen?Remedy Replace the lamp unit.(Æpage 69)NoteContact your dealer for repair services when indicator persists to light after taking thesezmeasurements.J WARNING indicatorIndicator Lights in red. Blinks in red.StatusThe projector detects an abnormalcondition and cannot be turnedon.The temperature inside the projector is abnormally high.The projector cannot be turned on. And the indicator also blinks in red.CheckUnplug the AC power cordand plug it again to turn on theprojector.- Did you provide appropriate space for the projector to beventilated? Check the installing condition to see if the airvents of the projector are not blocked.- Has the projector been installed near an Air-Conditioning/ Heating Duct or Vent?- Are the filters clean?RemedyIf the projector is turned off again,unplug the AC power cord andcontact the dealer or the servicecenter for service and checkup.- Provide good installing condition to your projector.- Move the installation of the projector away from the ductor vent.- Replace filters.NoteIf indicator persists to light or blink after taking these measurements, please contact your dealer for repairzservices. Do not leave the projector on. It may cause an electric shock or a fire hazard.The projector detects an abnormal condition and cannot be turned on. Unplug the AC power cord and plug it again to turnzon the projector. If the projector is turned off again, unplug the AC power cord and contact the dealer or the service centerfor service and checkup. Do not leave the projector on. It may cause an electric shock or a fire hazard. |
