2)Press the button to proceed to the initial setting.Initial setting (projector setup)Set each item.1)Pressasto select an item.ItemDescriptionPage[PROJECTION METHOD]Set [PROJECTION METHOD] depending on the installation mode.After completed the initial setting, you can change the setting from the [PRO-JECTOR SETUP] menu → [PROJECTION METHOD].79[SCREEN FORMAT]Set the screen format (aspect ratio) and display position of the image.After completed the initial setting, you can change the settings of each itemfrom the [DISPLAY OPTION] menu → [SCREEN SETTING].73[SCREEN POSITION]Set the display position of the image.After completed the initial setting, you can change the settings of each itemfrom the [DISPLAY OPTION] menu → [SCREEN SETTING].74[STANDBY MODE]Set the operation mode during standby. The default setting is [NORMAL],you can use the network function during standby. If you want to reduce thepower consumption, it can be set to [ECO]. After completed the initial setting,you can change the setting from the [PROJECTOR SETUP] menu → [ECOMANAGEMENT] → [STANDBY MODE].812)Pressqwto switch the setting.3)Press the button.fConfirm the setting value and complete the initial setting.NotefIf you press the button in the initial setting (projector setup) screen, you can go back to the initial setting (displaylanguage) screen.Making adjustments and selectionsIt is recommended that images are projected continuously for at least 30 minutes before the focus is adjusted.3)3)6)4)1) 8)7)9)4)5)6)1)Rotate the focus lever to adjust the focus of the projected image roughly. (Æpage 45)2)Change the settings of the [PROJECTOR SETUP] menu → [PROJECTION METHOD] depending on theinstallation mode. (Æpage 79)fRefer to “Navigating through the menu” (Æpage 53) for the operation of the menu screen.3)Press the button on the control panel or the input selection (,, f, and buttons on the remote control can also be used to switch theinput signal.ENGLISH-43Chapter 3Basic Operations - Powering on/off the projector