|
4) Adjust the front, back and sideway tilt of the projector with the adjustable feet. (Æ page 34)5) Move the vertical lens shift dial to adjust the position of the image.6) If the input signal is an analog RGB signal, press the button on the controlpanel or the remote control.7) Rotate the zoom lever to adjust the size of the image to match the screen.8) Rotate the focus lever again to adjust the focus of the projected image.9) Rotate the zoom lever again to adjust the zoom and the size of the image to match the screen.Notef When the projector is switched on for the first time after purchase as well as when the [PROJECTOR SETUP] menu →[INITIALIZE ALL] is executed, the initial setting screen is displayed after projection starts.Powering Off the Projector1) 2)2)2)1) 2)3)1) Press the power button <v/b> on the control panel or on the remote control.f The following message appears.2) Press qw to select [OK], and press the button.(Or press the power button <v/b> on the control panel or on the remote control again.)f Projection of the image will stop, and the power indicator lights in orange. (The fans keeprunning.)3) Wait until the power indicator lights or blinks in red.f The projector enters standby mode when the power indicator lights or blinks in red.Notef While the power indicator is lighting in orange, the lamp is being cooled down and the projectorcannot be turned on. Wait until the power indicator stops lighting or blinking in red to turn on theprojector again.f When packing the projector for transportation and storage, please make sure that each indicator is off.Direct Power Off functionYou can disconnect the power cord from the wall outlet or turn off the power breaker switch even during projection.Attentionf Do not disconnect the power cord from the wall outlet or turn off the power breaker switch in a short time (about 1 minute)after the lamp is lit. Doing so may cause the lamp fail to light while you powering on the projector next time, or result inpremature deterioration of the lamp.Notef When using the Direct Power Off function, you cannot restart the projector immediately after disconnecting the power cordfrom the wall outlet or turning off the power breaker switch. The lamp remains high temperature and needs to cool down, soit sometimes takes a longer time than usual for the lamp to light up again.44 - ENGLISHChapter 3 Basic Operations - Powering on/off the projector PreviousNext |